BIG DAISHOWASWS68-110CKB6MADE IN JAPAN PBCSWS6890E708090KAISERBORING SYSTEMSWS BORING HEADQuick and Precise Diameter AdjustmentKAISER ROUGH BORING HEADBIG DAISHOWASWS BORING HEADThe KAISER SWS Boring Head is perfect for setups without a presetter.It allows for quick and effortless diameteradjustments,ensuring precision and efficiency every time.The two cartridges are connected to each other by the Synchro Setter,providing simultaneous diameter adjustmentto both cartridges.Final diameter setting is possible using a simple measuring device,such as a micrometer ordial caliper.Two CartridgesMaximumMinimumDiameterDiameterCartridges areDiameter Adjustmentlinked by theUsing A SimpleSynchro SetterMeasuring Device2E TYPE FOR BLIND HOLES (TO SHAPE FLAT SURFACES)Select the same CK NoCOOLANTRANGE:g1.614"-4.331"THROUGHSWS HEAD SWS CARTRIDGECK NoSWS Cartridge (Sold SeparatelylBalance Cut Only;Step Cutting is Not PossibleSynchro Setter [Included]eDCatalogCK NoCartridgeLSynchro SetterClamp Bolt SetBelleville Spring SetWeightNumberSparel(Sparel(Spare】1.614-2.126SWS4154E1.1SWS41-66CKB4CK41.850SWS41SYSW41SSSW41BS2.087-2.598SWS5366E1.12.087-2.756SWS5370E1.85W553-86CKB5CK52.244SWS53SY2.717-3.386SWS6986E20SW53BS2.678-3.543SWS6890E3.5SW568-110CKB6CK62.795SWS68SY3465-4.3314.0Synchro setter,clamp bolt,and washer are includedThe machining diameterrange is the value when using an insertCompatible spare products listed in the table are notincluded andwith a corner radius of.031must be purchased separatelyNot intended to be used as a fine boring tool for precision boreswith tolerances less than +/-.004purchased separatelyAll SWS heads have coolant holes as standardBIGKAISER ROUGH BORING HEADBIG DAISHOWASWS CARTRIDGEETYPE FOR BLIND HOLES (TO SHAPE FLAT SURFACES]CatalogHeadNumberTypeInsertScrew Set1.614-2.126SW54154ESW541-66CKB4CC.09032.087-2.59802.087-2.756SWS53-86CKB5CC.12042.717-3.386SWS6986E2.677-3543SWS68-110CKB6CC.1204S55-20IP3.465-4.331SWS88110EEach cartridge model consists of a pair of cartridges and an insert clamping wrenchInserts must be ordered separatelyThe machining diameter range is the value when using an insert with a corner radius of.031Cannot be used with SWheadsINSERTSNoCatalogRadiusCornerWorkpieceCuttingNumberMaterials1CCGM090304EFMIT1500A)2Alloy Steel/Carbon SteelCermet(P10]031Alloy Steel/Carbon SteelCermet(P10].1253753016Alloy Steel/Carbon SteelCoated Carbide P2鞚